Easy to use, hasslefree and you can hang your voile or net in minutes, with no screws or fixings!

Heading: Suitable for a slot top heading net, voile or curtain

Weight: Tension rods are suitable for lightweight voile and net curtains, and may significanlty bow if a heavier curtain is used, however we do offer centre supports which can help with this issue:

Centre Supports: 1 pack contains: 2x centre supports, 2x sticky pads & 4x screws CLICK HERE to view this product or add to basket above.

Instructions;

• - Thoroughly clean surface before sticking
• - Leave hook up for 24 hours before using
• - In areas of moisture or extreme temperatures you may need to use extra super glue

Diameter: The end of the pole measures 15mm in diameter, with the remaining pole just smaller at around 10mm - this will fit a 3cm slot or bigger

Size: Sizes shown are the minimum and maximum length each pole extends to, however to create ample tension, chose a rod that extends wider than your recess by at least 20cm. A greater tension, creates a stronger and firmer hold for your curtain

Fitting: Either extend the rod 1-2cm wider than the recess and squeeze it in, or twist the rod from inside the recess until it is firmly in place

Example: Your window recess measures 59cm wide. The rod that measures 40-60cm will be extended to its maximum and will be too weak. Therefore, choose the 51-91cm rod and that will then give plenty of tension

Please note, the 2 longer sizes above 120cm may need a adhesive centre support, these are available in net rod accessories. If you are using tension rods at very wide windows, above 200cm wide, we recommend reading our article on Using Twist & Fit tension rods on wide windows. For extra wide windows, please look at our Extra Strong Twist & Fit Tension Rod.